Majestic Software Dash 8-Q400

reativando tópico

Saiu hoje o update 1.017... simplesmente espetacular, tem que instalar o 1.016 antes (para quem ainda não o fez)... até o pneu estoura agora!

É BETA ainda não é? Por isso que não baixei ainda.

Belo update! Muitas correções e adições interessantes.
Segue a lista:

Código:

AUTOPILOT:
+ Added ALT OFF mode on pitch wheel change during ALT mode
+ Changing preselected altitude in ALT Acquire mode will re-select ALTSEL and engage the PITCH mode


SYSTEMS:
+ EGPWS: bank angle test will not be performed if already done prior to saving the situation
+ Main Gear: Included the blown tyre simulation and breaking alterations on hard touchdown
+ Pressurization: Opening emergency hatch will depressurize the aircraft
+ Pressurization: Bleed air packs will be able to provide the air to the other side aircondition units
+ Electrics: APU DC Gen Voltage reduced by 0.5V to simulate correct load
+ Electrics: STBY Battery will no longer disconnect from LEFT MAIN BUS during battery assistend engine start
+ Electrics: Fixed strobes and position lights working without power
+ Electrics: AUX PUMP will no longer be able to operate without AC power
+ Electrics: IAS Mismatch will cause Elevator Trim and Elevator Feel C/Ls to come on
+ MTOP button- an alternate function is implemented
+ ADC: ADC will restore the last qnh after test
+ Hydraulics: Normal braking and steering will no longer work without hydraulics
+ AFCS: AFCS mode Acquire flag in LNAV mode only comes when LNAV is engaged
+ Antiice: Fixed the airframe - boot inflation sequence on the wings step 3
+ Sound: Modified Engine sounds to make the Nh sound cone prop rpm dependent
+ Sound: Chime will only repeat after previous chime ended (Seat belts case)

FMS:
+ Fixed the PVOR page
+ Added Crossfill progress indication
+ TUNE Page is fully re-designed
+ Holding will correctly terminate if PROCEED is allowed upon the next passing of the holding waypoint
+ Info page: Fixed the bug of forcing every waypoint to be of type NAV, added the correct waypoint type identification
+ ListAirways page: Fixed incorrect airway to waypoint designation
+ VNAVPage: Fixed VNAV offset functionality
+ VNAVPage: Target VS indication will be replaced with VS estimate with 45 seconds intervals during VNAV operation
+ VNAVPage: Fixed VNAV disconnect message on Cruise mode activation
+ FPLPage, FPLTemplate, LISTPage: each next fpl page will begin with the last waypoint from the previous page
+ FPLDepart, FPLArrive pages will show the last data. Added MENU function
+ FPLArrive: Cursor will move to approach select line after STAR is selected
+ FPL: Fixed the NO LINK indication
+ FPL: Manually entered altitude for waypoint will read as @
+ FPL: Disallow entering the altitude less than specified at waypoints with restriction @orAbove
+ FPL SUMMARY: Fixed local time calculation
+ Fuel Page 1: Changing average pax weight on fuel menu page will update pax total weight on fuel page 1
+ Fuel page 1: total reserve will show is all 3 (alternate, holding, reserve) exist (0 or more entered)
+ Fuel page 1: Default setting for Fuel entry is "total"

INSTRUMENTS AND GAUGES:
+ replaced Hydraulic STBY and PTU pushlights with newer versions
+ PFD: WPT alerts are magenta with inverse indication
+ PFD: Fixed AFCS warnings logic
+ PFD: Added DG AHRS mode annunciator
+ PFD: Altitude bug will turn to CYAN 300 feet from target altitude
+ PFD: Fixed the TCAS test IVSI indication
+ PFD: Barometric connection will default to 1013.25 (29.92In)
+ PFD: Flight Director is now centered inside the aircraft sign (not over it)
+ ND: FORMAT button will not reset the RANGE and DATA settings when alternating between MAP and ARC
+ ND: Color of the EGPWS elevation peaks will represent the color of the respective elevation
+ ED: Added AF TEST ABORTED message
+ ARCDU: Added timer to DIM/BRT function
+ ARCDU EXP and PG1/2 behavior fixed
+ ARCDU Removed ATC STBY setting from the ATC expanded page
+ ARCDU channel will switch to 1 after passing 8
+ Fixed manual pressure INC/DEC switch on the overhead panel, having opposite effect. Added spring-loaded function
+ Setting EFIS screens brightness to zero will not cause them to report a failure
+ Stby VHF panel: Fixed the fonts, implemented 888.88 indication on test
+ Gear horn switch left/right clicks for LEFT down, RIGHT up
+ Fixed tooltip on prop deice mode selector
+ Steering Caution Light is permanently off since we don't simulate castoring properly
+ Aligned FMS screen with LSKs on FMS Popup

SIM INTEGRATION:
+ Added support for engine start during GSX addon -assisted pushback
+ Setting MSFS Engine1 and Engine2 Mixture according to engine running flag for other addons

DOCUMENTATION:
+ Included the new Control Panel guide version
+ systemDescription guide includes the FPL WIND function
+ Added the Performance manual
+ SampleFlight guide is updated

OTHER:
+ MS Windows 10 compatibility- related modifications

reativando o tópico

Mandaram o e-mail avisando que o PRO sai amanhã com um código de desconto para upgrade. Alguém vai?

Nem consigo voar direito com o pilot, imagina com o pro. Esse eu passo, rs....

Eu também Flavio, um excelente addon mas voei muito pouco.

Parace ótimo o shared cockpit...

hahahahahahahahah Esse povo não perde tempo. Essa musica é maior sucesso no youtube, tem um que fica repetindo a musica por 10 HORAS seguidas rs.... https://www.youtube.com/watch?v=09m0B8RRiEE

VSP4264 escreveu:Este é O AVIÃO em termos de turbohélice no FSX, ahhh que lindo seria um ATR600 (42 e 72) no mesmo nível.

Seria perfeito ATR! Minha aeronave preferida!

Porque não há interesse?

flavioSSA escreveu:hahahahahahahahah Esse povo não perde tempo. Essa musica é maior sucesso no youtube, tem um que fica repetindo a musica por 10 HORAS seguidas rs.... https://www.youtube.com/watch?v=09m0B8RRiEE

Em 1.5x fica ainda mais hilário.

Versão freighter???? Vi uns carros atrás dos pilotos

Alguém comprou a versão Pro que permite o compartilhamento do cockpit?

Vi um vídeo hoje no youtube que gostei muito ; ele é totalmente compartilhado (até o tampa sol do avião quando um mexe o outro pode ver -> vídeo 5:35)


Muito interesse em comprar, apesar do dólar estar salgado, mas se não tiver ninguém para voar fica complicado...

Realmente é um avião um pouco mais complicado (dae a graça do shared cockpit) mas tem muito vídeo tutorial no youtube.

Abraço

Reativando tópico

++++++++NOTAM 20161503++++++++
++++++++++++++++++++++++++++++
+++++PREPAR3D v3.2 PATCH++++++
++++++++++++++++++++++++++++++

Captains & First Officers :-

The long awaited Prepar3D v3.2 patch has officially been released. We think that most of your will find this update to be an improvement over the beta that has been in circulation for a few months. As always if you are experiencing issues please :- POST THEM ON THE MAJESTIC SOFTWARE FORUMS:-

The Patch can be downloaded from the USER AREA of you account on the Majestic Software Support Forum, and follow the included instructions.

1.018c patch for MJC8 Q400 PRO edition. Issue 15.03.2016

+Pre-requisits
Installed MJC8 Q400 PRO edition version 1.018 (with or without 1.018b1 or b2 patch)

+Installation instructions
Copy the entire folder structure from "FSX_Prepar3Dv2.5" or from "Prepar3Dv3.2" folder into the mjc8q400 folder, overwriting the existing files

+ Changes since version 1.018

+ docs: fixed randomEngineFailureOnV1.mgs script
+ docs: fixed the system description manual XFILL section, new Define Waypoint sections
+ cpan: Fixed the flickering of the MJC84 Control Panel
+ CFMSSystem: Changes to Heading to Altitude/Course to Altitude logic
+ CHGSSystem: Removed the rwy elevation from requirements of the TO mode
+ CScriptingSystem: When loading the situation scripts, scripting engine will attempt to look for a double point ".." file name if the initial script is not found

+ PFD, HUD graphics: Fixed the incorrect VOR APP and VOR armed indication
+ Optimization of the gauge dll size
+ P3D V3.1 connectivity: Adjusted for the P3D V3.1 update
+ P3D V3.1: Fixed the incorrect sound in the exterior views
+ P3D V3.1: updated panel.cfg to fix the P3D error message
+ P3D V3.1: Fixed the aircraft rolling problem on selection
+ P3D V3.1: Changes to the P3D connector to prevent the P3D window related error messages

+ Changes since version 1.018b2

+ CFMSSystem: ETP/PNR will accept any waypoint, not only the airports
+ CFMSSystem: VNAV PATH page behavior changes to be more in line with the real FMS
+ CFMSSystem: Added ground deicing option under SERVICES
+ CFMSSystem: Selecting DTO or manual leg change will result in XTK cancel
+ CFMSSystem: Fixed the problems with some approaches due to error in calculation of the point of tracks intersection
+ CAntiiceSystem: Added the estimation of the aircraft icing status upon loading the aircraft on the ground
+ Cold and Dark script is updated
+ ASN sync: GSX deicing will now deice the Q400 on the ground (FDE wise and visually)
+ Exterior MDLs: Fixed the bounding box for the correct zoom on exterior models
+ CScriptingSystem: Fixed max operand length for longer lines (now allowed up to 256 characters)
+ Scripts: Takeoff and ReadyToTaxi : added Gear Pins remove
+ Add-ons compatibility (virtual airlines): FSX/P3D engines will now be started and shut down in sync with Q400 engines to allow for the correct block time calculation
+ Prepar3D V3.2 compatibility (3.1 and 3.0 are no longer supported)

Disponível em seu USER AREA do site da Majestic: http://majesticsoftware.com/mjc8q400/support.html

Turma do FSX não está inclusa neste update não?

VSP4264, acabou de sair outro patch pro PILOT, que tem a versão FSX e a versão P3D incluida:
https://www.facebook.com/permalink.php?story_fbid=940691266045809&id=249628718485404

Arquivo: MJC84PILOT_1.018c_all_versions.zip

Este ser o melhor turboprop do seu vida no FSX...

Reativando o tópico

Versão 1.020 lançada hoje, must have para quem usa, agora colocaram até as portas no FMC para facilitar abertura (tipo PMDG).